HP 3150 EN - Manual (Page 49)

EN Control panel 47
Paper Bin is Empty
Please Add Paper The paper input bin is empty. Load paper. If paper is already loaded,
remove it. Check for and remove any
jammed sheets and discard them. Then,
reload the paper stack in the paper input
bin.
Password must be 4
Digits An attempt was made to enter a password
that was not four digits. Re-enter four-digit password.
Paused (Memory
Full) The HP LaserJet 3100/3150 product
memory is full, and the current job in the
document feeder tray is paused to wait for
memory to become available. Reduce activity on the HP LaserJet
3100/3150 product, or wait for other jobs
to finish so that memory will be freed.
If there are faxes set up to be polled or
sent at a future time, you may want to
cancel these jobs to free memory.
PC Not Detected
Address Invalid If you tried to send a document to an e-
mail address in a one-touch key, speed-
dial code, group-dial code, or to one that
you entered manually at the control panel,
the product must be directly connected to
a computer using a parallel cable, the
computer must be on, and a compatible e-
mail program must be installed on the
computer. Make sure that the parallel cable is
securely connected between the
computer and the HP LaserJet
3100.3150 product.
Make sure that the computer is on.
Make sure that a compatible e-mail
program and the JetSuite Pro software
are installed on the computer.
PC Print Timed Out The print job took too long to print, and the
HP LaserJet 3100/3150 product timed
out. Let the “print jobs retry” continue for five
minutes. If the HP LaserJet 3100/3150
product still does not print, cancel the
current print job and resend it.
Phone Number Error Too many characters were entered when
dialing a phone number. The maximum number of characters
that can be entered is 60. If you have a
number longer than 60 characters,
break the number into smaller chunks.
Enter the first part of the number, and
press
R EDIAL /P AUSE as the last
character in the first number. Then,
enter the second part of the number as
if it were a second number going to a
group. When the product dials, it will
treat both numbers as if they are one.
Table 9. Control panel messages
Message Cause Solution