HP 3150 EN - Manual (Page 123)

EN Internal assemblies 121
Fuser exit roller assembly
1 Remove all covers, the RFI shield, the printer door, the exit roller,
the delivery assembly, the fuser pressure plate, the front casing,
the heating element, the pressure roller, and the face-up/face-
down lever.
2 Remove the gear from the left end of the roller shaft by pressing
down on the catching mechanism with the small flatblade
screwdriver and pulling the gear away.
3 Remove the exit roller assembly by pressing the small, white tab
upward (callout 1) and rotating it around (callout 2).
4 Slide the exit roller assembly forward and out to the right of the
printer.
Figure 49. Fuser exit roller assembly removal
2 2
2 1