HP 8000M - Manual (Page 113)

6-37
Configuring the Switch
Network Monitoring Port Features
C
o
n
fig
u
rin
g
th
e
Sw
itc
h
Figure 6-26. Example of Selecting a Monitoring Port
5. Use the Space bar to select which port to use for the monitoring port, then
press
[v] to move to the Monitor parameter. (The default setting is Ports,
which you will use if you want to monitor one or more individual ports on
the switch.)
6. Do one of the following:
• If you want to monitor individual ports, leave the Monitor parameter
set to Ports and press
[v] to move the cursor to the Action column
for the individual ports. Press the Space bar to select Monitor for each
port that you want monitored. (Use
[v] to move from one port to the
next in the Action column.) When you are finished, press [Enter], then
press [S] (for Save) to save your changes and exit from the screen.
• If, instead of individual ports, you want to monitor all of the ports in
a VLAN, press the Space bar to select VLAN in the Monitor parameter,
then press
[v] to move to the VLAN parameter (figure 6-21 on page
6-38). Then press the Space bar again to select the VLAN that you want
to monitor. When you are finished, press
[Enter], then press [S] (for
Save ) to save your changes and exit from the screen.
Move the cursor to
the Monitoring Port
parameter.