HP 8000M - Manual (Page 81)

6-5
Configuring the Switch
IP Configuration
C
o
n
fig
u
rin
g
th
e
Sw
itc
h
Configuring IP Addressing from the Web Browser
Interface
Figure 6-7. Configuring IP Addressing on the Web Browser Interface
3. If multiple VLANs
are configured,
select a VLAN.
4.To enable manual entry
of the IP address, set this
to “Manual”.
5. Enter an IP address, subnet
mask, and, if needed, the IP
address of the default gateway.
6.Click on this to activate
the changes you made in
steps 3 - 5.
2. Click here. 1. Click here.
Parameter Description
VLAN If you have configured multiple VLANs, then use this parameter to
select the VLAN to which you want to assign an IP address. Otherwise,
leave it set to the default.
IP Configuration The method the switch uses to acquire its IP configuration.
• DHCP/Bootp (default): The switch attempts to get its IP
configuration or its complete configuration from a DHCP or Bootp
server.
• Manual: Enables you to manually enter the IP configuration into the
next three fields.
• Disabled: Network management access to the switch over IP is
disabled.