HP 8000M - Manual (Page 160)

6-84
Configuring the Switch
Load Balancing: Switch Meshing
C
o
n
fig
u
rin
g
th
e
Sw
itc
h
Further Information:
■ For further operating information and restrictions, refer to “Operating
Notes for Switch Meshing” on page 6-87.
■ For further explanation and examples of switch meshing, refer to HP’s
Network City site at the following URL on the world wide web:
http://www.hp.com/go/procurve
Using the Console To Configure Switch Meshing
N o t e If VLAN support is not currently activated in the switch, use the instructions
under “To Activate VLANs” on page 6-56 to activate VLAN support before
continuing here. (VLAN support must be activated before you configure
switch meshing, even if multiple VLANs are not configured.)
To Access Switch Meshing
1. Before configuring switch meshing, ensure that VLAN support is enabled
on the switch.
2. From the Main Menu, select:
3. Switch Configuration
5. Advanced Features
2. Load Balancing (Meshing, FEC, Trunks)
3. Press [E] (for Edit) to access the load balancing parameters.