Hearth and Home Technologies Direct Vent Gas Appliance EDV3633L - Manual (Page 11)

Heatilator • Eclipse • 4049-229 Rev F • 11/08 11
H. Lighting Instructions (IPI)
The IPI system may be operated with two D-cell batteries. When using batteries, unplug the transformer. To prolong bat-
tery life, remove them when using the transformer.
A.
This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
B.
BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor
.
WHA
T T
O
DO IF
YOU SMELL
GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier
, call the fire
department.
LIGHTING INSTRUCTIONS
1.
ST
OP! Read the safety information above on this label.
2.
Tu
rn wall switch to the "OFF" position or thermostat to
the lowest setting.
3.
Tu
rn off all electric power to the appliance.
4.
This appliance is equipped with an ignition device which automatically lights the pilot. Do NOT try to light the pilot by hand.
5.
W
ait five minutes to clear out any gas. If you then smell gas,
ST
OP! Follow "B" in the safety information above on this label. If
you don't smell gas, go to the next step.
6.
To
turn on the burner
, turn on all electric power to this appliance
and turn on the wall switch or set the thermostat to the desired setting.
7.
If the appliance will not operate, follow the instructions "T
O TURN
OFF GAS T
O
APPLIANCE" and call your service technician or gas
supplier
.
TO
TURN OFF GAS T
O
APPLIANCE
1.
Tu
rn off wall switch or set thermostat to lowest setting.
2.
Tu
rn off all electric power to the appliance if service is to
be performed.
3.
Push the gas control lever in and move to the "OFF" position or push the gas control lever to the "OFF" position. Do not force.
4.
Replace the control access panel.
Due to high surface temperatures, keep children, clothing and furniture away
.
Keep burner and control compartment clean. See installation and operating instructions accompanying the appliance.
W
ARNING:
If you do not follow these instructions exactly
, a
fire or explosion may result causing property damage, personal injury or loss of life.
FOR
YOUR SAFETY
READ BEFORE LIGHTING
33631D
C.
Use only your hand to push in and move the gas control valve or turn the gas control knob. Never use tools. If the lever or knob will not move by hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water
. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been under water
.
This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air
.
This appliance must be installed in accordance with local codes, if any; if not, follow
ANSI
Z223.1 or
, in Canada, current CAN/CGA-B149.
W
ARNING:
Improper installation,
adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner's information manual provided with the appliance. For assistance or additional information consult a qualified installer
, service
agency or the gas supplier
.
CAUTION:
Hot while in operation. Do not touch.
Keep children, clothing, furniture, gasoline and other liquids having flammable vapors away
.
W
ARNING RISK OF FIRE
This appliance is intended to burn a specified gas fuel only
. Do
not attempt to use with solid wood fuel or another type of fuel. Do not attempt to modify or use any other type of gas burner system.
*
Also certified for installation in a bedroom or a bed-sitting room.
*
For U.S. only!
W
ARNING:
Disconnect the electric power before
servicing. If for any reason the original wire supplied with the appliance must be replaced, it must be replaced with 105° C or its equivalent. For use with natural gas or propane.
A conversion
kit as supplied by the manufacturer shall be used to convert this appliance to the alternative fuel. This appliance must be properly connected to a venting system in accordance with the manufacturer's installation instructions.
NA
TURAL
GAS