Hearth and Home Technologies Direct Vent Gas Appliance EDV3633L - Manual (Page 3)

Heatilator • Eclipse • 4049-229 Rev F • 11/08 3
Safety Alert Key:
• DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury.
• WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury.
• CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
• NOTICE: Used to address practices not related to personal injury.
Table of Contents
A. Congratulations 2
B. Warranty 5
1 Listing and Code Approvals
A. Appliance Certifi cation 7
B. Tempered Glass Specifi cations 7
C. BTU Specifi cations 7
D. High Altitude Installations 7
E. Non-Combustible Materials Specifi cation 7
F. Combustible Materials Specifi cation 7
G. Electrical Codes 7
H. Requirements for
the Commonwealth of Massachusetts 8
User Guide
2 Operating Instructions
A. Gas Fireplace Safety 9
B. Your Fireplace 9
C. Fan Kit 10
D. Clear Space 10
E. Fixed Glass Assembly 10
F. Remote Controls, Wall Controls and
Wall
Switches 10
G. Before Lighting Fireplace 10
H. Lighting Instructions (IPI) 11
I. Lighting Instructions (Standing Pilot) 12
J. After Fireplace is Lit 13
K. Frequently Asked Questions 13
3 Maintenance and Service
A. Maintenance Tasks-Homeowner 14
B. Maintenance Tasks-Qualifi ed Service Technician 15
Installer Guide
4 Getting Started
A. Typical Appliance System 17
B. Design and Installation Considerations 18
C. Tools and Supplies Needed 18
D. Inspect Appliance and Components 18
5 Framing and Clearances
A. Selecting Appliance Location 19
B. Constructing the Appliance Chase 20
C. Clearances 20
D. Mantel and Wall Projections 21
6 Termination Locations
A. Vent Termination Minimum Clearances 22
7 Vent Information and Diagrams
A. Approved Pipe 24
B. Vent Table Key 24
C. Use of Elbows 24
D. Measuring Standards 24
E. Vent Diagrams 25
8 Vent Clearances and Framing
A. Pipe Clearances to Combustibles 30
B. Wall Penetration Framing 30
C. Install the Ceiling Firestop 31
D. Install Attic Insulation Shield 32
9 Appliance Preparation
A. Securing and Leveling the Appliance 33
10 Installing SLP Vent Pipe
A. Assemble Vent Sections 34
B. Assemble Slip Sections 34
C. Securing the Vent Sections 35
D. Disassemble Vent Sections 35
E. Installing Metal Roof Flashing 36
F. Install RF4-8 37
G. Installing Vertical Termination Cap 38
H. Assemble and Install Storm Collar 38
I. Install Heat Shields and
Horizontal
Termination Cap 39
11 Gas Information
A. Fuel Conversion 41
B. Gas Pressure 41
C. Gas Connection 41
D. High Altitude Installations 41
12 Electrical Information
A. Wiring Requirements 42
B. Standing Pilot Ignition System Wiring 42
C. Intellifi re Ignition System Wiring 42
D. Optional Accessories Requirements 42
E. Electrical Service and Repair 43
F. Junction Box Installation 44
G. Wall Switch Installation for Fan (Optional) 44
13 Finishing
A. Mantel and Wall Projections 45
B. Facing Material 45