Husqvarna 305 - Manual (Page 16)

16 - English
3. INSTALLATION
• Charging station (6)
• Loop wire for the boundary wire and guide
wire (16)
• Transformer (20)
• Low voltage cable (17)
• Staples (21)
• Connector for the loop wire (18)
• Screws for the charging station (19)
• Measurement gauge (22)
• Solderless coupler for the loop wire (23)
During installation you will also need:
• Hammer/plastic mallet to simplify putting the
staples in the ground
• Combination pliers for cutting the boundary
wire and pressing the contact units together.
• Edge cutter/straight spade if the boundary wire
must be buried. Installation of the charging
station
3.2 Installation of the charging
station
Ideal position of the charging station
Take the following aspects into consideration when
identifying the best location for the charging station:
• Allow for 10 feet (3 metres) of free space in
front of the charging station
• It must be possible to lay at least 4.9 feet
(1.5 metres) of boundary wire straight out to
the right and left of the charging station.
• Close to a wall socket. The supplied low
voltage cable is 33 feet (10 metres) long.
• A level surface on which to place the charging
station.
• Protection from water spray, for instance from
irrigation
• Protection from direct sunlight
• Place in the lower part of a working area that has
a major slope
• Possible requirement to keep the charging
station out of sight of outsiders
• Any aesthetic preferences
For examples of where best to install the charging
station, See 7. Garden example on page 50.