Husqvarna 305 - Manual (Page 26)

26 - English
3. INSTALLATION
Laying the boundary wire in towards the charging
station
The boundary wire must be laid in line with the rear
end of the charging station. If the boundary wire is
laid in any other way, the robotic lawn mower may
find it hard to find the charging station.
In many cases, the straight wire section to the left of
the charging station can be reduced to 3 feet
(1 metres).
Depending on how the boundary wire is laid in the
rest of the installation, in certain cases, the straight
wire section to the right of the charging station may
need to be extended.
Joining the boundary wire
Use an original connector if the boundary wire is not
long enough and needs to be spliced. It is waterproof
and gives a reliable electrical connection.
Insert both wire ends into the connector. Check that
the wires are fully inserted into the connector so that
the ends are visible through the transparent area on
the other side of the connector. Now press down fully
on the button on top of the connector. Use a pair of
pliers if the button on the connector is difficult to press
down by hand.
IMPORTANT INFORMATION
Twinned cables, or a screw terminal block
that is insulated with insulation tape are not
satisfactory splices. Soil moisture will cause
the conductors to oxidise and after a while
result in a broken circuit.