HP vs80 - Manual (Page 20)

20 Installing the Autoloader Chapter 1
4. Attach the terminator to the remaining SCSI connector on the rear panel
of the autoloader (if the autoloader is the last or only device on the SCSI
bus). Otherwise, attach the cable to the next device on the SCSI bus, and
ensure that the last device on the SCSI bus is properly terminated.
5. Attach the female connector on the power cable to the power connector
on the rear panel of the autoloader.
6. Plug in the power cable to the nearest properly grounded power outlet.
WARNING To disconnect all power from the autoloader, remove the power
cord from the outlet.
7. Plug in the host server or workstation and all attached devices.
8. Turn on the autoloader by setting the power switch on the front panel to
the ON position. You will need to use the tip of a pen or similar item to
move the switch. Turn on any other devices you turned off earlier. Check
the LCD display to make sure the autoloader is receiving power. If it is not,
check the power connections and your power source.
During the Power-On Self Test (POST), all four LEDs are illuminated briefly,
followed by just the Ready/Activity LED flashing. When the initialization
sequence is complete, the LCD screen displays the Home screen.
9. Turn on the server.