HP vs80 User Manual

Page 61

Advertising
background image

Chapter 4

Diagnostics and Troubleshooting 61

Bad/defective/contaminated

media

If the Media Attention LED is cleared using a cleaning cartridge

and then immediately reappears each time a particular

cartridge is reloaded, and you have confirmed that the suspect

cartridge is not an invalid cleaning cartridge (DLTtape III or non-

DLT1), that cartridge should be suspected as being

contaminated.
— If this occurs, export the cartridge, clean the tape drive again

and then load a known good cartridge. In some cases, a

cartridge can be worn out, have been improperly degaussed,

have bad calibration tracks, or have a bad tape directory

recorded by another drive type such as DLT 7000 or DLT

8000.

— Any cartridge that is suspected of being defective or

contaminated should NOT be reused in any drive. Cartridges

that are suspected as being improperly degaussed or

containing incompatible formats such as DLT 7000 or DLT

8000 must be thoroughly degaussed before use.

Errors Displayed on Front Panel

“!” in autoloader operator

panel inventory display

See

Operator’s Panel Overview

on page 24 for more

information.

There is an error code on the

LCD display

Look up the error code, try to resolve the failure, and power cycle

(see

page 66

).

Table 4

Troubleshooting Table

Problem

Solution

Advertising