HP vs80 - Manual (Page 67)

Chapter 4 Diagnostics and Troubleshooting 67
3 0 83 Inventory not valid. The cartridge inventory is not valid because of
manual changes or previous fatal errors. Update
the inventory using the Re-inventory option in the
Configuration menu. See page 38 or power
cycle.
3 0 84 Source empty. There is no cartridge in the location where a
cartridge move was issued.
3 0 85 Destination full. The location where a cartridge move was issued
already contains a cartridge.
3 0 86 Mail slot access rejected. User attempted to access the mail slot, but media
removal was prevented by the host.
3 0 87 Operation timeout. A command did not complete in the required
amount of time.
3 0 88 Communications error during
loop-back.
Cycle power on the autoloader and attempt the
operation again. If the error recurs, contact your
technical support representative.
3 0 89 System test timeout. There was a communication timeout between the
drive and loader during the System Test.
3 0 8F Recovered loader error. Loader error recovery successful. Your diagnostic
tool can provide details of the original loader
error.
3 0 90 Mechanical Initialization failure. The robotics were not able to move to the safe
mechanical initialization position. Manual
intervention is necessary.
3 0 91 Inventory scan failure. Fatal robotic error occurred during the inventory
scan.
3 0 92 Preposition failed. Belt positioning error occurred during
'Preposition' command.
3 0 93 Cartridge load error. A failure occurred while trying to load a
cartridge from the drive to its slot.
Table 5 Error Codes
Error Code Description Details