HP vs80 - Manual (Page 65)

Chapter 4 Diagnostics and Troubleshooting 65
9. After removing the cartridges from the desired carriers, reinstall each
carrier on the autoloader belt (see Figure 17 ).
— Make sure that the rollers on the bottom of the carrier are aligned in
the carrier tracks.
— Make sure that the belt post beneath each carrier is inserted into the
proper autoloader belt loop.
Note There are unused loops on the belt. The proper belt loops have
an extra bump on the outside of the loop. See Figure 17 .
Figure 17 Installing the Carrier
10. Ensure the carrier is properly installed on the belt by gently pressing on the
top of the carrier and sliding it back and forth. If it is properly attached to
the belt, it should not move. If it does, reinstall the carrier.
11. Replace the top cover of the autoloader and reinstall the eleven cover
screws and mounting brackets.