HP vs80 User Manual
Page 54
54 Diagnostics and Troubleshooting
Chapter 4
To terminate the autoloader, locate the terminator in the accessories
package and press it firmly into either of the two SCSI connectors on the
rear panel of the autoloader. Secure the terminator by tightening the
finger-screws until snug. The supplied terminator is “dual mode” and will
work on both Low-Voltage Differential (LVD) and Single Ended (SE) SCSI
buses. A green LED on the terminator indicates that the unit is attached to
a SCSI bus running in LVD mode. A red LED on the terminator indicates
that the unit is attached to a SCSI bus running in SE mode. If the LED is not
on, check all SCSI and power connections and confirm that the unit is
attached to a valid SCSI bus.
■
Compatibility:
Ensure that the autoloader is compatible with the SCSI host adapter and
backup application you plan to use. For a list of compatible SCSI adapters
and application software, check with your SCSI host adapter
manufacturer, backup application vendor, or the HP support website at
■
SCSI Host Adapter Installation:
Verify that you have installed your SCSI host adapter correctly. Refer to the
manual that came with your SCSI host adapter for installation and
troubleshooting instructions. Pay particular attention to any steps
describing the settings of various jumpers and/or switches on the host
adapter. Make sure that the host adapter is properly seated in the
motherboard slot and the operating system correctly detects the host
adapter. Make sure that the proper device driver is installed for the SCSI
host adapter.
■
Backup Application Installation:
Refer to the documentation included with your backup application for
instructions on how to verify proper installation. Many backup software
packages require an additional module to communicate with the
autoloader robotics.
■
Device Driver Installation:
If applicable, make sure that the proper ISV and/or autoloader driver is
installed. For more information, see