HP E1418A - Manual (Page 77)

DIAGnostic
The DIAGnostic subsystem contains commands used to check the module
configuration, enable or disable all outputs simultaneously, change a channel’s
mode without opening and closing the output relay, and check the state of the trigger
on all channels.
Subsystem Syntax DIAGnostic
:CALibration
:OUTPut
[:MODE] < path >
[:MODE]?
:CONFigure?
:OUTPut
:ALL
[:STATe] < state >
:SOURce n
:FUNCtion
:MODE < mode >
:TRIGgered?
DIAGnostic:CALibration:OUTPut[:MODE]
DIAGnostic:CALibration:OUTPut[:MODE] < path > sets the voltage calibration
path for the module to either the CAL output terminals or at each output channel.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
< path > discrete CALBus or CHANnel none
Comments •
The typical calibration mode for the module is through the CAL output terminals.
Following
*RST or power-on, the default calibration mode is through the CAL
output terminals (and this command is not needed).
•
This command with the CHANnel parameter, sets calibration to be performed at
each channel’s output terminals (and so includes the channel output relay
contacts).
•
This command must be sent before any CALibration n :CONFigure:VOLTage? or
CALibration n :CONFigure:CURRent? query.
•
*RST State: Calibration paths set to use the CAL output terminals.
DIAGnostic
76 HP E1418A SCPI Command Reference Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com