HP E1418A - Manual (Page 98)

STATus:OPERation:ENABle?
STATus:OPERation:ENABle? returns the value of the mask set for the Operation
Status Register.
Parameters Returns: 16-bit signed integer (int16).
STATus:OPERation[:EVENt]?
STATus:OPERation[:EVENt]? returns the value of the contents of the Operation
Status Event Register. Reading the register clears all bits in the register.
Parameters Returns: 16-bit signed integer (int16).
Comments •
Bit 0 of this register (decimal 1) is the only defined bit in this register.
•
This bit is set if the CALibration:CONFigure:RESistance? ,
CALibration n :CONFigure:VOLTage? , or CALibration n :CONFigure:CURRent?
command has been received and the calibration process is not yet complete.
•
*RST Condition: no effect.
•
*CLS clears the contents of the Operation Status Register.
•
STATus:PRESet does not affect the contents of the Operation Status Register, but
does disable reporting the Summary bit to the Status Byte Register.
STATus:PRESet
STATus:PRESet presets all Enable Registers to 0 (zero). The command has no
effect on Condition or Event Registers.
STATus
Chapter 3 HP E1418A SCPI Command Reference 97
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com