Hearth and Home Technologies Cyclone-BC - Manual (Page 33)

Heat & Glo • Cyclone-BN, Cyclone-BC • 2073-900 Rev. N • 10/08 33
12 12
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
C. Accessories
Install approved accessories per instructions included
with accessories. See Service Parts List for appropriate
accessories. Refer to Section 15.
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• Using non-listed accessories voids warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
WARNING
E. Glass Assembly Installation
D. Marbles and Polished Rock Placement
Placing the Marbles or Rock
With the door installed on the appliance apply your choice
of decorative base material. Spread the material evenly
making sure not to pile the material too high. Material
should be no deeper than approximately one inch. No
material should be placed under glass assembly.
Figure 12.2 Position the bottom of the glass assembly
by centering it on the platform as shown.
Figure 12.3 Carefully tip the assembly in toward the cyl-
inder stops as shown on top.
Figure 12.1 Lower the glass platform by using a screw-
driver and turning the four screws counterclockwise to
lower the platform at least 1/2 inch.
CYLINDER
STOPS
GLASS
PLATFORM