HP 2425 - Manual (Page 127)

7URXEOHVKRRWLQJ
&URZQ&RS\
 7URXEOHVKRRWLQJ3ULQWHU3UREOHPV
7URXEOHVKRRWLQJ&URZQ&RS\
8QGHUVWDQGLQJWKH/('V
The scanner has three LEDs—Power (amber), Ready (green), and
Jam (red). Alone and in combination they indicate the scanner’s
status.
If these LEDs are. . . they indicate. . . Do this . . .
Power Ready Jam
Off Off Off Not ready to
copy. Ensure that the power cord is
firmly plugged into the power
supply and the scanner and
that the scanner is turned on.
On Off Off The scanner
has been turned
on. Wait for the Ready LED to
light.
On On Off Ready to copy. Copy.
On On On Paper jam. Remove the paper jam. See
chapter 5, the “Removing ADF
Paper Jams” section, of the
Options manual.
On Off Blinking ADF cover open. See chapter 5, the “Removing
a Paper Jam” section, of the
Options manual for
information on opening and
closing the ADF cover. If
necessary, turn the scanner
off and on again.
On Blinking Off Lamp failure—
the lamp is either
burnt out or too
dark due to
aging. Replace the lamp. See
chapter 5, the “Replacing the
Lamp” section, of the
Options
manual for instructions.
On Blinking Blinking A service
problem.
Check that the shipping
bracket was removed. If this
does not solve your problem
contact your vendor.