HP 2425 - Manual (Page 134)

'LVN3UREOHPV
406785%23ULQW6\VWHP2SHUDWLRQ 
1RW$OO3DJHV3ULQW
If the printer stops printing in the middle of your file, try the following:
1 Check your cable.
You could have the wrong kind of cable, or your printer may not
be configured for the correct cable and port.
2 Make sure no one pressed the Cancel key while your job was
printing.
3 Check the message window to see if the cassette you are
using needs more media.
3ULQWHU:LOO1RW'XSOH[
If the error message DUPLEXER ABSENT appears in the message
window, make sure you have the optional duplexer correctly installed.
See the
Options guide for information on installing the duplexer. If you
have correctly installed the duplexing unit and configured the printer
from the front panel to duplex (Operator Control/Def.Duplex), but the
printer continues printing simplex, you may need additional memory
allocated to the frame buffer. See chapter 3,“Advanced Printing Fea-
tures,” in this guide for additional information on memory required for
duplexing.
'LVN3UREOHPV
,'(,QWHUQDO+DUG'LVN1RW2Q/LQH
„
If your printer doesn’t have enough memory, then you need to
enable disk swapping. See chapter 4, “Printer Configuration,” in
the
Reference guide for information on how to enable this option
through the Administration/Memory/Enable Disk Swap menu.