HP SP 3300 User Manual
Page 54
Installing Printer Software in Windows
8
5
The list of printers available on the network appears. Select the
printer you want to install from the list and then click Next.
• If you do not see your printer on the list, click Update to
refresh the list, or select Add TCP/IP Port to add your printer
to the network. To add the printer to the network, enter the
port name and the IP address for the printer.
To verify your printer’s IP address or the MAC address, print a
Network Configuration page.
• To find a shared network printer (UNC Path), select Shared
Printer [UNC] and enter the shared name manually or find a
shared printer by clicking the Browse button.
N
OTE
: If you cannot find your machine in network, please turn off
the firewall and click Update.
For Windows operating system, click Start
→ Control Panel and
start windows firewall, and set this option unactivated. For other
operating system, refer to its on-line guide.
T
IP
: If you want to set a specific IP address on a specific network
printer, click the Set IP Address button. The Set IP Address window
appears. Do as follows:
a. Select a printer to be set with a specific IP address from the list.
b. Configure an IP address, subnet mask, and gateway for the
printer manually and click Configure to set the specific IP
address for the network printer.
c. Click Next.
6
Select the components to be installed and click Next.
N
OTE
: You can change the desired installation folder by clicking
[Browse].
7
Select the components to be installed. After selecting the
components, the following window appears. You can also
change the printer name, set the printer to be shared on the
network, set the printer as the default printer, and change the
port name of each printer. Click Next.
To install this software on a server, select the Setting up this
printer on a server checkbox.
8
After the installation is finished, a window appears asking you to
print a test page. If you so desire, select the corresponding
checkbox and click Finish.
Otherwise, just click Finish.