Honeywell 9782 Series - Manual (Page 110)

Conductivity/Resistivity Analyzer/Controller
9782 Series Conductivity/Resistivity Analyzer/Controller - Operator’s Manual 7/99 9-2
9.2 System Status Messages
Related to operation of Analyzer/Controller
System status messages, displayed on the alarm stripe, are related to normal operation of the
Analyzer/Controller. These messages are listed in Table 9-1.
Table 9-1 System Status Message
MESSAGE WHEN DISPLAYED
AUTO CLEAN This message is displayed temporarily and indicates that
an AutoClean operation is active. All alarms and outputs
are held for the duration of the AutoClean operation.
To see how much time is remaining until the next
scheduled AutoClean operation, use the DISPLAY key to
access the special Time Remaining screen.
CAL ADJ FAILED This message indicates that a calibration operation has
been unsuccessful.
RETRIEVING DATA This message is displayed during I/O setup, configuration,
and calibration while the unit retrieves data from its
memory.
ENTERING DATA This message is displayed during I/O setup, configuration,
and calibration while the unit processes data entered by
the user.
INPUT RANGE TOO HIGH
INPUT RANGE TOO LOW User input was either greater than or less than the
allowable range.