HP R4.2 - Manual (Page 462)

A
Summary of Commands detach
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 423
detach
The detach command places a card or channel in the NONEX state. If a card
is detached, it can then be replaced by hot swapping (that is, like-for-like
replacement). The blue LED indicates that is ready to be removed from the
system.
Synopsis
detach unit number [-i] [-n]
Description
The detach command places a unit currently in the manual-out-of-service
(MANOOS) state into the nonexistent (NONEX) state. Before this can be
done, the unit must be taken from the in-service (INSERV) or broken
(BROKEN) state and put in the MANOOS state using the remove command.
The parameters for the detach command are:
• unit — Identifies the unit. The choices are “channel” or “card.”
• number — Specifies the channel or card number, a range of channel or
card numbers in the form m–n, or the word “all” for all of the channel or
card numbers. Card numbers are in the form
card#[.port#] where port# is
the port of the card # . If port# is not given, all ports of the card specified
are detached. If no card number or channel is given, the system displays
a syntax message.