Example, See also – HP R4.2 User Manual
Page 634
A
Summary of Commands
start_vs
UCS 1000 R4.2 Administration 585-313-507
Issue 3 April 2000 595
the
start_vs
command to start it again. The start_vs
also should be used if
the system was rebooted or powered down after stop_vs
was used.
The start_vs
command checks to see if the user stopped the system with the
stop_vs
command. The start_vs
command places all cards placed in the
manual-out-of-service (MANOOS) state with the stop_vs
command in the
in-service (INSERV) state.
You must be logged on to the system console as
root
to use the start_vs
command.
Since the /vs/data/spchconfig file cannot be edited while the voice system
processes are running, it is a good idea to check the value of nbufs in the
/vs/data/spchconfig
file before executing the start_vs
command. The value
of nbufs defines the number of speech buffers. For the voice system to
operate properly, nbufs must be set to 2.5 times the number of active
channels.
Example
The following example starts the voice system software:
See Also