HP R4.2 - Manual (Page 466)

A
Summary of Commands diagnose card
UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 427
diagnose card
The diagnose card command tests a card while it is in service.
Synopsis
diagnose card card# [option]...
Description
The diagnose card command is done at the card level for any card in the
system. The
card number option is the card number you want to diagnose.
The word “all” can be used to specify all cards.
This command changes the temporary state of a unit to diagnostic (DIAG). If
a card is stuck in the INSERV state, use the diagnose card card# immed
command. This temporarily removes the unit from the busy state
unconditionally and places it in the manual-out-of-service (MANOOS) state.
Note that any calls on the card when the “immed” option is used are dropped
immediately.
For T1 cards the valid options are:
• -n — Prevents prompting from the system during diagnostic tests. The
diagnostics assume the default values during the test and the user is
informed when the diagnostics are completed.