Teledyne LeCroy WaveJet 300A Series Remote Control Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for WaveJet 300A Series Remote Control Teledyne LeCroy
Manuals
| Recognized languages: | English |
|---|---|
| Pages: | 60 |
| Size: | 741 KB |
Show table of contents
Read manual
Document Outline
- April, 2009
- 1. INTRODUCTION TO WAVEJET 300A REMOTE CONTROL INTERFACES
- 2. INSTALLATION OF GPIB AND TCP/IP
- WaveJet Remote Control Interface Installation Procedure (GPIB and TCP/IP)
- 2.1 List of IEEE 488.1 interface functions subsets implemented
- 2.2 Device behavior when the address is changed outside the range 0 to 30
- 2.3 When a user-initiated address change is recognized by the device
- 2.4 Device setting at power-on, including commands which modify the power-on settings
- 2.5 Message exchange options
- 2.6 Functional elements used in constructing device-specific commands
- 2.7 Buffer size limitations related to block data
- 2.8 List of <PROGRAM DATA> elements
- 2.9 Response syntax for every query.
- 2.10 Device-to-device message transfer traffic that does not follow the rules for <RESPONSE MESSAGE> elements
- 2.11 Size of block data responses
- 2.12 List of common commands and queries which are implemented
- 2.13 State of the device after successful completion of the Calibration query
- 2.14 Maximum length of the block used to define the trigger macro, if *DDT is implemented
- 2.15 Macro parameters
- 2.16 Response to the identification common query, *IDN?
- 2.17 Size of protected user data storage area if the *PUD command and *PUD? query are implemented
- 2.18 Size of resource description if the *RDT command or *RDT? query are implemented.
- 2.19 States affected by *RST, *LRN?, *RCL, and *SAV
- 2.20 Scope of self-test performed by the *TST? query
- 2.21 Additional status data structures used in the device’s status reporting
- 2.22 For each command, a statement describing whether it is overlapped or sequential
- 2.23 For each command device, the documentation shall specify the functional criteria that are met when an operation complete message is generated in response to that command.
- 3. REMOTE MENU
- 4. LIMITATIONS ON REMOTE FUNCTION
- 5. RESPONSE FORMATS
- 6. REMOTE COMMANDS