Teledyne LeCroy WaveJet 300A Series Remote Control - Manual (Page 8)

WaveJet 300A Series
8
917976 Rev A
2.1 List of IEEE 488.1 interface functions subsets implemented
Table 2-1. List of IEEE 488.1 interface functions
subsets implemented
Interface function Subset
Source Handshake SH1
Acceptor Handshake AH1
Talker T6,TE0
Listener L4, LE0
Service Request SR1
Remote Local RL2
Parallel Poll PP0
Device Clear DC1
Device Trigger DT1
Controller C0
Electrical Interface E2
2.2 Device behavior when the address is changed outside the range 0 to 30
• With GPIB, values that do not fall within the range of 0 to 30 cannot be selected.
• TCP/IP has 4 fields, IPv4, for which values that do not fall within the range of 0 to 255 cannot be selected.
2.3 When a user-initiated address change is recognized by the device
• GPIB immediately recognizes the address change.
• TCP/IP recognizes the change when the system is rebooted after the change.
2.4 Device setting at power-on, including commands which modify the power-on settings
• At power-on, device settings are restored to their values when the device was last powered off.
• A command for changing the power-on settings is not installed.
2.5 Message exchange options
Size and behavior of input buffer
The size of the input buffer is 512 bytes.
Queries that return more than one <RESPONSE MESSAGE UNIT>
See the list of commands.
Queries that generate a response when parsed
See the list of commands.
Queries that generate a response when read
See the list of commands.
Commands that are coupled
See the list of commands.