Installation of gpib and tcp/ip, Wavejet 300a remote control manual – Teledyne LeCroy WaveJet 300A Series Remote Control User Manual
Page 7
WaveJet 300A Remote Control Manual
917976 Rev A
7
2. INSTALLATION OF GPIB AND TCP/IP
The Remote Function uses GPIB, TCP/IP and USB as the interface. GPIB is installed according to IEEE488.1 and
IEEE488.2, while TCP/IP is installed according to LeCroy VICP.
WaveJet Remote Control Interface Installation Procedure (GPIB and TCP/IP)
The WaveJet remote control interfaces, WJ-A-LAN and WJ-A-GPIB are compatible with all WaveJet units running
firmware version 3.06 or higher. For firmware upgrades please visit www.lecroy.com. The firmware and firmware
installation instructions are available for download.
1. Confirm the installed firmware version is 3.06 or higher. To do this press U
TILITIES
on the front panel, select
Status and Update and then select Update. If it is 3.06 or greater proceed to step 2. If not please update the
firmware.
2. With the power off, remove the screws from the rear panel option slot.
3. Insert the WJ-A-LAN and/or WJ-A-GPIB interfaces into the slot and fasten the screws.
4. Turn the WaveJet power on and then press U
TILITIES
on the front panel.
5. In
the
Utilities menu a new selection, Remote will be available, if two cards are installed there will be a choice
between TCP/IP and GPIB. If only one is installed there will only be one listing.
6. For GPIB operation use the A
DJUST
knob to set the appropriate GPIB address.
7. For TCP/IP use the A
DJUST
knob to set the IP address. Rotate the knob to change values; push the knob to
jump from field to field. The WaveJet works with static IP addressing only.
8. Press the soft key next to the down arrow to move to Subnet Mask and Default Gateway. Rotate the knob to
enter values; push the knob to change fields.
9. After entering the correct addresses, press Enter at the bottom of the remote menu and reboot the scope.
The WaveJet can be operated with both WJ-A-LAN and WJ-A-GPIB installed, or with only one interface card
installed. However, two GPIB or two LAN cards cannot be installed simultaneously.