Teledyne LeCroy WaveJet 300A Series Remote Control - Manual (Page 51)

WaveJet 300A Remote Control Manual
917976 Rev A
51
Trigger TSRC
Command/Query
DESCRIPTION The TSRC command defines the trigger signal source. The
trigger type determines the trigger signal source
setting. The TSRC? query returns the current trigger
signal source setting.
COMMAND SYNTAX TSRC <source>
<source> := {CH1, CH2, CH3, CH4, EXT, EXT10, LINE} (for
WJ354/334/324/314)
<source> := {CH1, CH2, EXT, EXT10, LINE} (for
WJ352/332/322/312)
QUERY SYNTAX TSRC?
RESPONSE FORMAT <source>
The current trigger signal setting is identified in
<source>.
REMARKS When TTYP is not EDGE, TSRC LINE command is not
performed and reports device-specific error (DDE).
Others *TST?
Query
DESCRIPTION The *TST? query implements the internal self-test and
returns the response showing whether an error is
detected in the test.
COMMAND SYNTAX
QUERY SYNTAX *TST?
RESPONSE FORMAT <status>
<status>:=+000000 No error occurred in the self test.
<status>:=-000001 CH1 ACQ MEMORY CHECK ERROR
<status>:=-000002 CH2 ACQ MEMORY CHECK ERROR
<status>:=-000003 CH3 ACQ MEMORY CHECK ERROR
<status>:=-000004 CH4 ACQ MEMORY CHECK ERROR