Teledyne LeCroy WaveJet 300A Series Remote Control - Manual (Page 12)

WaveJet 300A Series
12
917976 Rev A
*ESE? Standard Event Status Enable Query Yes
*ESR? Standard Event Status Register Query Yes
*GMC? Get Macro Contents Query No
*IDN? Identification Query Yes
*IST? Individual Status Query No
*LMC? Learn Macro Query No
*LRN? Learn Device Setup Query No
*OPC Operation Complete Command Yes
*OPC? Operation Complete Query Yes
*OPT? Option Identification Query No
*PCB Pass Control Back Command No
*PMC Purge Macro Command No
*PRE Parallel Poll Register Enable Command No
*PRE? Parallel Poll Register Enable Query No
*PSC Power On Status Clear Command No
*PSC? Power On Status Clear Query No
*PUD Protected User Data Command No
*PUD? Protected User Data Query No
*RCL Recall Command Yes
*RDT Resource Description Transfer Command No
*RDT? Resource Description Transfer Query No
*RST Reset Command Yes
*SAV Save Command Yes
*SRE Service Request Enable Command Yes
*SRE? Service Request Enable Query Yes
*STB? Read Status Byte Query Yes
*TRG Trigger Command Yes
*TST? Self-Test Query Yes
*WAI Wait-to-Continue Command Yes
2.13 State of the device after successful completion of the Calibration query
Not implemented.
2.14 Maximum length of the block used to define the trigger macro, if *DDT is implemented
Not implemented.
2.15 Macro parameters
Maximum length of macro labels, maximum length of the block used to define a macro, and how recursion
is handled during macro expansion, if macro commands are implemented
Not implemented.