Teledyne LeCroy WaveJet 300A Series Remote Control - Manual (Page 19)

WaveJet 300A Remote Control Manual
917976 Rev A
19
is identified in <mode>.
REMARKS WJ 324, WJ314, WJ322 and WJ312 set the bandwidth limiter
to 20 MHz when these scopes receive "BWL 100M".
Status *CLS
Command
DESCRIPTION The *CLS command clears the entire status data
register.
COMMAND SYNTAX *CLS
QUERY SYNTAX
RESPONSE FORMAT
Cursor CMSR?
Query
DESCRIPTION The CMSR? query returns the currently displayed cursor
measurements.
COMMAND SYNTAX
QUERY SYNTAX CMSR?
RESPONSE FORMAT <measure1>, <measure2>, <measure3>, <measure4>,
<measure5>, <measure6>, <measure7>
• Current cursor measurements are displayed in
<measure1> to <measure7> in
<NR3 Numeric Response Data> format.
• When the cursor mode is disabled or the data cannot
be measured, the query returns +9.91E+37.
• Seven types of cursor measurement results are output,
respectively separated by a comma, regardless of
whether cursor mode has been selected. For items not
covered by the measurement, the query returns
+9.91E+37.
• The table below shows the relationship between
<measure1> to <measure7> and
cursor mode.
<measure1>:= CH1
<measure2>:= CH2
<measure3>:= CH3
<measure4>:= CH4
<measure5>:= MATH
<measure6>:= delta t
<measure7>:= 1 / delta t
When MATH is FFT, M1:TRA is ON and CURM is VATH, CMSR?
returns frequency at the cursor of the FFT waveform for
<measure7>.
REMARKS When calculating the cursor measurement values of the
YT display Amplitude, Value at Cursor, and XY display
ch Amplitude in the model WJ352/332/322/312,
<measure3> and <measure4> return "+9.91E+37".