Teledyne LeCroy WaveJet 300A Series Remote Control User Manual
Page 30
WaveJet 300A Series
30
917976 Rev A
Math FHZPOS
Command/Query
DESCRIPTION
The FHZPOS command sets the frequency at the center of
the screen in Hz, to set horizontal position of FFT
waveform.
The FHZPOS? query returns the frequency at the center
of the screen of FFT waveform in Hz.
COMMAND SYNTAX
FHZPOS <fft_hpos>
<fft_hpos> is set in <DECIMAL NUMERIC PROGRAM DATA>
format. A value beyond the setting range is rounded to
a permissible closer value.
QUERY SYNTAX
FHZPOS?
RESPONSE FORMAT
<fft_hpos>
<fft_hpos>:= <NR3 Numeric Response Data> format.
<fft_hpos> shows the horizontal position (position) of
the FFT waveform.
REMARKS
Math FHZZOOM
Command/Query
DESCRIPTION
The FHZZOOM command sets the horizontal zoom factor of
the FFT waveform.
The FHZZOOM? query returns the horizontal zoom factor
of the FFT waveform.
COMMAND SYNTAX
FHZZOOM <fft_hzoom>
<fft_hzoom>:= {1, 2, 5, 10}
A value other than previously specified is rounded to
a permissible larger value.
QUERY SYNTAX
FHZZOOM?
RESPONSE FORMAT
<fft_hzoom>
<fft_hzoom> shows the horizontal zoom factor of the FFT
waveform.
REMARKS
When FFT trace is off, FHZZOOM command reports
command-execution error (CME).
Horizontal FRQCNT?
Query
DESCRIPTION
The FRQCNT? query returns the trigger signal frequency
result that is measured by internal trigger frequency
counter.
COMMAND SYNTAX
QUERY SYNTAX
FRQCNT?
RESPONSE FORMAT
<value>
<value>:= <NR3 Numeric Response Data> format. <value>
shows the frequency of trigger signal.