Teledyne LeCroy WaveJet 300A Series Remote Control - Manual (Page 44)

WaveJet 300A Series
44
917976 Rev A
Status TESE
Command/Query
DESCRIPTION The TESE command sets the trigger event status enable
register. In other words, it determines whether the
summary message of the trigger event status register
is connected to the status byte. The TESE? query reads
the current setting of the trigger event status enable
register.
COMMAND SYNTAX TESE <value>
<value>:=0 to 255
QUERY SYNTAX TESE?
RESPONSE FORMAT <value>
The current setting of the trigger event status enable
register is identified in <value>.
The format is <NR1 Numeric Response Data>.
Status TESR?
Query
DESCRIPTION The TESR? query reads the trigger event status
register. In other words, it determines whether a
single measurement is completed. After the status is
read, the contents of the register are cleared.
COMMAND SYNTAX
QUERY SYNTAX TESR?
RESPONSE FORMAT <status>
Each bit of the trigger event status register is
weighted by a power of 2. The format is <NR1 Numeric
Response Data> and the value ranges from 0 to 255.
Trigger THTM
Command/Query
DESCRIPTION The THTM command defines the trigger hold-off time. The
THTM? query returns the defined trigger hold-off time.
COMMAND SYNTAX THTM <holdoff>
<holdoff>:= The <DECIMAL NUMERIC PROGRAM DATA> format
is used, and the suffix is also valid.
Available range is 0 to 50.0 s.
If specified holdoff is < 200 ns, the trigger hold-off
is turned off.
QUERY SYNTAX THTM?
RESPONSE FORMAT <holdoff>
The currently set hold-off time is identified in
<holdoff>. If the hold-off time is set to
"OFF", 0 is input to <holdoff>. The format is <NR3
NUMERIC RESPONSE DATA>.
REMARKS THTM command reports device-specific error (DDE) when
TTYP is not EDGE..