Teledyne LeCroy WaveJet 300A Series Remote Control User Manual
Page 26
WaveJet 300A Series
26
917976 Rev A
Data transfer
DTPOINTS
Command/Query
DESCRIPTION
The DTPOINTS command defines the amount of waveform
data to be transferred. The
DTPOINTS? query returns the defined amount of waveform
data to be transferred.
COMMAND SYNTAX
DTPOINTS <points>
<points>:=1 to (waveform data length - DTSTART)
Any values exceeding this range are rounded to the
maximum or minimum permissible value, whichever is
nearest.
QUERY SYNTAX
DTPOINTS?
RESPONSE FORMAT
<points>
The defined amount of waveform data to be transferred
is identified in <points>. The
format is <NR1 Numeric Response Data>.
REMARKS
(Transfer start address) + (Amount of data to be
transferred) > (Total amount of waveform data)
When DTPOINTS command causes the above case, the
transfer start address is rounded to a permissible
value.
Data transfer
DTSTART
Command/Query
DESCRIPTION
The DTSTART command defines the transfer start address
for waveform data transfer.
The DTSTART? query returns the defined transfer start
address.
COMMAND SYNTAX
DTSTART <start>
<start>:=0 to (waveform data length - 1)
Any values exceeding this range are rounded to the
maximum or minimum permissible value, whichever is
nearest.
QUERY SYNTAX
DTSTART?
RESPONSE FORMAT
<start>
The defined start address for waveform data transfer
is identified in <start>. The format is <NR1 Numeric
Response Data>.
REMARKS
(Transfer start address) + (Amount of data to be
transferred) > (Total amount of waveform data)
When DTSTART command causes the above case, the amount
of data to be transferred is rounded to a permissible
value.