Henny Penny SCR-6/8 - Manual (Page 14)

SCR-6/8
Figure 4
Figure 5
5. Attach casters to the caster bracket (Figure 4), mounting
the two locking swivel casters to the control side of the
unit and the non-locking casters to the customer side. Use
the 5/16 inch hex head bolts, 5/16 inch locking washers,
5/16 inch nuts and 5/16 inch flat washers (use 2 flat
washers per bolt; one on the bottom side of caster bracket
and one on the top-side) which are provided. Completed
installation shown in Figure 5.
6. Set the unit onto its casters and carefully lift the rotisserie
and place it on top of the display, or bottom rotisserie, with
the controls on the same side.
Take care when moving the unit to prevent personal
injury. The SCR-8 weighs approximately 500 lbs.
(230 kg) and the SCR-6 weighs 380 lbs. (172 kg).
7. Remove the three side panel screws from the top unit
and remove the three top side panel side screws from the
bottom unit.
8. Mount the stacking brackets to each side of the units, as
shown in Figure 6, using the screws removed in step 7.
9. Unit is now ready for use.
Figure 6
2-6. STACKING AND OUTBOARD
CASTER INSTALLATION
INSTRUCTIONS (Continued)
2-6 105