Henny Penny SCR-6/8 - Manual (Page 21)

SCR-6/8
3-3. INSTALLATION OF DISCS,
RODS, AND SPITS
1. Fit discs up to appropriate disc support on each side
of unit.
2. Place each end of the rod assembly into the hubs on each disc.
3. Slide the collars onto each hub of discs.
4. Slide retention rings over hubs and into slot on rod.
5. Slip angled spits onto discs, with the “V” of the angled spits
towards the rod.
Fit the spit with the “V” towards the rod. Reversing the spit will
result in spits tilted at an angle.
When removing the rod assembly, make sure indicator is
pointed up towards top of unit. If it is pointed down, the
rod assembly will fall.
203 3-5