Henny Penny SCR-6/8 - Manual (Page 25)

SCR-6/8
3-12. CLEANING 1. Turn all controls to OFF and disconnect the electrical
PROCEDURES power supplied to the unit.
To avoid severe burns, allow the unit to cool before
cleaning.
2. Remove the discs and rod assembly and take to a sink to
clean them thoroughly. (See Installation of Discs, Rods, and
Spits section.)
If door of unit is partially open it is designed to close
automatically. To keep door open, position door fully open.
Be sure to keep groove in the rod clean of debris. The
retaining ring must fit securely in the groove to keep
rod assembly from falling and damaging unit, or
causing personal injury.
3. Pull drain pan partially out and unscrew drain plug to
discard grease into another container.
4. Remove drain pan, vent panels (side vents first), back
panel, and drip trays from unit, and take to a sink to
clean thoroughly.
The top vent panel (covering air heaters), is slotted to
the right on the SCR-8 and to the left on the SCR-6.
203 3-9