Henny Penny SCR-6/8 - Manual (Page 30)

SCR-6/8
4-3. SPECIAL PROGRAM The Special Program Mode is used to set more detailed parameters
MODE (Level 2) The Special Program Mode is accessed by pressing and holding the
PROGRAM SETTINGS (P) button for 8 seconds, or until the display
shows “L-2”. “LEVEL 2” flashes in the top display, then “SP PRG”
shows in the display. It then asks for a code which is 1, 2, 3. The mode
consists of the following features:
z Degrees Fahrenheit or Celsius
z
Oven type: SCR-6 or SCR-8
z Language: English, French, German, Spanish
z
Audio volume
z Audio tone
z
Alarm auto cancel
z
Cook-to-hold auto
z
Idle Mode enabled
z
Mult. cook steps
z Program locked by code
z
Radiant setpoint offset
z Initialize system
To exit from the Special Program Mode, press and hold program
P button for 2 seconds, or wait 2 minutes and control will automatically
exit Special Program Mode.
Degrees Fahrenheit or Celsius (SP-1)
After entering the access code, the top display shows “SP-1” and
“TEMP UNITS”. The middle display shows
“° F” or “° C”. Pressing
the UP or DOWN button will toggle the display from “° F” to “° C”, or
vice versa.
Oven Type (SP-2)
After entering the access code (1,2,3), press and release the P button.
“OVEN TYPE” shows in the top display and “Scr-6” or “Scr-8”
shows in the middle display. This must match the type of unit before
programming, or the unit may not perform properly. This will be preset
from the factory. Pressing the UP and DOWN button will toggle the
display from one unit to another.
Language (SP-3)
After entering the access code (1,2,3), press the P button twice and
“LANGUAGE”, then “1=ENGL”, “2=FREN”, “3=GERM”, and
“4=SPAN”. The middle display will show a digit, 1 thru 4. Pressing
the UP and DOWN buttons under the digit will change the language
that shows on the displays.
Audio Volume (SP-4)
The volume of the speaker can be adjusted. After entering the access
code (1,2,3), press the P button three times. “AUDIO VOLUME”
shows in the top display, and a digit 1 thru 10 shows in the middle
display. 1 is the softest volume setting, 10 being the loudest. Use the
UP and DOWN buttons under the digits to set the desired volume.
4-4 203