Fluke NetDAQ 2645A - Manual (Page 304)

2640A/2645A NetDAQ
Users Manual
J-6
Associated configuration will change to reflect new instrument model.
Continue?
You are modifying an instrument model number in the Communications
Configuration File, which will also modify the instrument model number for the
associated icon on the Icon Bar.
Associated icon will change to the new number. Continue?
You are modifying an instrument BCN in the Communications Configuration File,
which will also modify the BCN for the associated icon on the Icon Bar.
Attempt to set instrument to invalid time - Verify your PC time!
When logging starts, the instrument time is set according to the clock on your PC.
If your PC date and time settings are invalid, the instrument time cannot be set and
this message will appear.
Reset the date and time on your PC. If this message continues to appear, check
your PC’s clock batteries and replace if necessary.
Attempt to start Trend Link failed!
Trend Link could not start.
Make sure Trend Link is installed. Note the directory used for the installation and
try again. If prompted for the directory location, enter the path to the location of
the Trend Link installation. If Trend Link is not installed, see the procedures in
Chapter 2.
Bad calibration input value - Check your source!
Your calibrator did not input a valid calibration value to the instrument.
Check your calibrator output, particularly for 4-wire connections (Ohms for
example) as the calibrator must be configured for both Sense and Source.
Base Channel Number must range from 1 to 99!
You tried to enter the number 00, or other characters. Select a number in the range
01 to 99.
Batch information in data set has been corrupted!
This will occur when NetDAQ Logger starts logging into an existing Trend Link
data file for which the batch information has been corrupted. The best workaround
is to start logging into a new Trend Link data file.