Fluke NetDAQ 2645A - Manual (Page 72)

2640A/2645A NetDAQ
Users Manual
2-40
COMM
Press the COMM key to review the parameters, or press and hold the COMM key
for 3 seconds to set the parameters.
Press the up/down arrow keys until dgAtE (default gateway) appears
in the primary display (COMM appears in the secondary display).
ENTER
Press the ENTER key. dgAtE appears in the secondary display, and ON or OFF is
in the primary display.
Press the up/down arrow keys to select either ON or OFF when in set
mode.
ENTER
Press the ENTER key to make the selection (pressing any other key will cancel
set operations.). If you select ON, the subnet mask appears. The subnet mask
display consists of four 3-digit segments: Sub0. Sub1. Sub2. Sub3.
Press the left/right arrow keys to select the desired number in each segment. The
selected digit is highlighted and the segment, for example Sub:0,
appears in the secondary display.
Press the up/down arrow keys to select the desired number 0 to 9, for the
positioned subnet mask digit. In this manner, select all 12 subnet mask
digits.
ENTER
Press the ENTER key to make the selection (pressing any other key will cancel
set operations). If you enter an incorrect subnet mask, Error appears for 2
seconds, and the subnet mask selection stays displayed. Otherwise, the default
gateway IP address appears. The default gateway display consists of four 3-digit
segments: gAt0.gAt1.gAt2.gAt3.
Press the left/right arrow keys to select the desired number in each segment. The
selected digit becomes highlighted and the segment, e.g. gAt:0,
appears in the secondary display.
Press the up/down arrow keys to select the desired number 0 to 9, for the
positioned default gateway IP digit. In this manner, select all 12 default
gateway IP digits.
ENTER
Press the ENTER key to make the selection (pressing any other key will cancel
set operations). If you enter an incorrect default gateway IP, Error displays for 2
seconds, and the default gateway IP selection stays displayed. Otherwise, the
procedure exits.
Figure 2-27. Reviewing and Setting the Subnet Mask and Default Gateway