Fluke NetDAQ 2645A - Manual (Page 325)

Error Messages & Exception Conditions
Error and Status Messages
J
J-27
Select at least one trigger type!
Your scan parameters do not include a type of trigger.
Configure your scan parameters to include at least one of the triggers: Interval
Trigger, External Trigger or Alarm Trigger.
Selected Trend Link Data Set already contains data for instrument
[BCN] Delete the Data Set or create a new Data Set.
The name you selected for your Trend Link data file is already being used by
another instrument.
Select another data file name for this Trend Link file or delete the old Trend Link
data set and try again. To delete old Trend Link data files, see "Deleting Old
Trend Link Files” in Chapter 5 of this manual.
Setup File Is Invalid!
Your setup file is corrupted.
Delete the setup file and recreate a new setup file with the same name.
Setup has changed. Save the changes?
You tried to exit the application or select another setup file without saving the
changes to the current setup file.
Select Yes to save the changes, No to not save the changes, or Cancel to return to
your previous operation.
Shunt Resistance value must range from 10 to 250 Ohms!
You entered an out-of-range shunt resistance for dc current measurements.
Enter a shunt resistance value between 10 and 250 Ohms. The default is 10 Ohms.
Socket Error!
Your host computer is not able to connect to the network.
Check that your networking software has not been corrupted and is correctly
installed. If necessary, reinstall your networking software as described in Chapter
2. Check that your Ethernet adapter is operating by using the diagnostic
procedures that are on the diskette supplied with the adapter. You may have
experienced a hardware failure in the Ethernet adapter.