Farallon Communications R9100 - Manual (Page 113)

AppleTalk Setup 11-7
EtherTalk Phase II por t is visible to other AppleTalk nodes. The default zone is also where new AppleTalk
nodes will appear. If you do not set a default zone, the first zone you create will be the default zone.
■ You can also set the range of EtherTalk Phase II network numbers. Select Net Low and enter the lower limit
of the network number range. Select Net High and enter the upper limit of the range.
■ Select the Seeding pop-up menu and choose the seeding method for the Netopia R9100 to use. (See
“Routers and seeding” on page 11-3 ).
You have finished configuring EtherTalk Phase II.
LocalTalk setup
Note: For instructions on making the physical connections for LocalTalk, see “Connecting to a LocalTalk
network” on page 4-8 .
In the AppleTalk Setup screen, select LocalTalk Setup and press Return. The LocalTalk Setup screen appears.
■ If you are using LocalTalk with the Netopia R9100, select LocalTalk Enabled and make sure LocalTalk is
set to On, which is the default.
Note: Since the LocalTalk connector attaches to the Auxiliar y por t on the router, that por t will no longer be
available for a third external modem.
■ Select LocalTalk Zone Name and enter a new or existing zone name.
Note: Your LocalTalk network may already have a zone and network number in place. For the Netopia
R9100’s LocalTalk por t to be par t of your LocalTalk network, it must have a network number and zone
name that matches the values in use on the LocalTalk network.
If another router is already present on the LocalTalk network that you will be connecting to the Netopia
R9100, use the zone name and network number used by that router for that LocalTalk network. Other wise,
your LocalTalk network may experience routing conflicts.
LocalTalk Setup
LocalTalk Enabled: On
LocalTalk Zone Name: Unnamed
LocalTalk Net Number: 33126
Seeding... Soft-Seeding
Use this screen to set up the LocalTalk Port Routing attributes.