Farallon Communications R9100 - Manual (Page 34)

5-2 User’s Reference Guide
Before running SmartStart
Be sure you have connected the cables and power source as described in Step 1 “Connect the Router” guide
contained in your Netopia folio.
Before you launch the Smar tStar t application, make sure your computer meets the following requirements:
PC Macintosh
System
software Windows 95, 98, or NT operating system MacOS 7.5 or later
Connectivity
software TCP/IP must be installed and properly
configured. See
“Configuring TCP/IP on
Windows 95, 98, or NT computers” on
page 5-6
MacTCP or Open Transpor t TCP/IP must be
installed and properly configured. See
“Configuring TCP/IP on Macintosh
computers” on page 5-10
.
Connectivity
hardware Ethernet card (10Base-T) Either a built-in or third-par ty Ethernet card
(10Base-T)
Browser
software Netscape Communicator™ or Microsoft Internet Explorer, included on the Netopia CD.
Required for web-based registration and web-based monitoring.
Notes:
• The computer running Smar tStar t must be on the same Ethernet cable segment as the Netopia R9100.
Repeaters, such as 10Base-T hubs between your computer and the Netopia R9100, are acceptable, but
devices such as switches or other routers are not.
• Smar tStar t for the PC will set your TCP/IP control panel to “Obtain an IP address automatically” if it is
not already set this way. This will cause your computer to reboot. If you have a specified IP address
configured in the computer, you should make a note of it before running Smar tStar t, in case you do not
want to use the dynamic addressing features built in to the Netopia Router and need to restore the fixed IP
address.