Farallon Communications R9100 User Manual
Page 62
8-2 User’s Reference Guide
■
Address Translation Enabled allows you to specify whether or not the router per forms Network Address
Translation (NAT) on the Ethernet WAN por t. NAT is enabled by default.
■
Local WAN IP Address allows you to manually configure an IP address for use on the Ethernet WAN por t.
The value 0.0.0.0 indicates that the device will act as a DHCP client on the Ethernet WAN por t and attempt
to acquire an address from a DHCP ser ver. By default, the router acts as a DHCP client on the Ethernet
WAN por t.
■
Local WAN IP Mask allows you to manually configure an IP subnet mask for use on the Ethernet WAN por t.
This item is visible only if you have configured a non-zero Ethernet IP Address; other wise, the router obtains
a subnet mask via DHCP.
■
The Filter Set pop-up allows you to associate an IP filter set with the Ethernet WAN por t. See
■
Remove Filter Set allows you to remove a previously associated filter set.
■
The Receive RIP pop-up controls the reception and transmission of Routing Information Protocol (RIP)
packets on the Ethernet WAN por t. The default is Both. The Transmit RIP pop-up is hidden if NAT is
enabled.
Routing Information Protocol (RIP) is needed if there are IP routers on other segments of your Ethernet
network that the Netopia R9100 needs to recognize. Set to “Both” (the default) the Netopia R9100 will
accept information from either RIP v1 or v2 routers. Alternatively, select Receive RIP and select v1 or v2
from the popup menu. With Receive RIP set to “v1,” the Netopia R9100’s Ethernet por t will accept routing
information provided by RIP packets from other routers that use the same subnet mask. Set to “v2,” the
Netopia R9100 will accept routing information provided by RIP packets from other routers that use
different subnet masks.
WAN Ethernet Configuration
Address Translation Enabled: Yes
Local WAN IP Address: 0.0.0.0
Filter Set...
Remove Filter Set
Receive RIP: Both
Aux Serial Port... Async Modem
Data Rate (kbps)... 57.6
Aux Modem Init String: AT&F&C1&D2E0S0=1
Set up the basic IP attributes of your Ethernet Module in this screen.