Falcon Graphics RJ-6000 Series - Manual (Page 32)

• Use a power supply that is separate from devices that produce
electrical noise.
• Don't have multiple connections on the power cord. These will
cause heating and fire. Take power directly from a household
power outlet.
• An earth lead must be used.
• Value settings will be recorded after the power switch has been
turned off. Wait for about 5 seconds before switching on again.
Plug the power cable into the power socket on the left side at the back of the
printer and insert the power plug into a power outlet that matches the following
power supply specifications.
Power Supply Specifications
Voltage
100 to 120 V AC ±10%, 200 to 240 V AC ±10%
Frequency 50/60 Hz ±1 Hz
Capacity Use a power outlet rated for at least 10 A
Connecting the Power Cable
31 RJ-6000 Series USER GUIDE Basic Edition
Preparing for Printing
CAUTION
NOTE
Back of Board Box
Power Cable