Falcon Graphics RJ-6000 Series User Manual
Page 88
When printing A0 size or larger widths, very small amounts of ink will be eject-
ed on the left edge for stable printing quality. The waste ink ejected on the left
side in that way is collected in a translucent bottle under the main unit (the
waste ink bottle).
Step 1
Since there is no panel display or lamp display when the waste liquid
absorbent sheet in the waste ink bottle is to be replaced, you should prepare
to replace the waste liquid absorbent sheet when you see that the bottle is
about half full. Have a new absorbent sheet, a thick vinyl bag and a pair of for-
ceps ready.
• Conditions vary for the waste ink bottle to become half full but
it will be after printing about 2000 A0 pages.
Step 2
Remove the waste ink bottle by turning
it to the left. Using absorbent sheet and
forceps, soak up the waste liquid in the
bottle and discard the waste liquid
absorbent sheet into the open vinyl
bag.
Step 3
The waste ink bottle, fitted with new waste liquid absorbent sheet, is installed
in the printer by turning it to the right.
Replacing Waste Liquid Absorbent Sheet (Waste Ink Bottle)
87
RJ-6000 Series USER GUIDE Basic Edition
Daily Maintenance
Waste Ink Bottle
NOTE