Falcon Graphics RJ-6000 Series - Manual (Page 40)

Step 5
Put the hold lever down.
• Remove the roll media and scroller from the main unit before
using.
• Don't load the media slantwise. The media size may be
misidentified and the printing will not be normal.
• If the roll media lamp is lit by the Control panel setting, a "Roll
media end" error may appear and printing will not terminate
normally or the media may be cut.
• Apart from the maximum size that may be loaded, cut media
can be loaded either longitudinally or laterally.
• Media has a printing surface and non-printing surface. Printing
on the non-printing surface may cause blurring or blemishes.
The printing surface is usually lighter.
Step 6
Close the cover. The head will move
automatically to detect the size of the
media.
Step 7 Removing the media
To remove the media, open the cover
and put the hold lever up, then remove
the media without touching the media
keeper blade.
39 RJ-6000 Series USER GUIDE Basic Edition
Loading the Media
Loading Cut Media
Preparing for Printing
NOTE
C o n f i r m P a p e r K i n d
P l o t O K