FORD SUPER DUTY F-SERIES 6C34-19A268-BA - Manual (Page 10)

F-SERIES
(March, 2005) 8
STATEMENTS OF CONFORMITY
STATEMENTS OF CONFORMITY
The following Statements of Conformity apply to vehicles that are produced for sale or importation into the United States or
Canada. The term “Incomplete Vehicle Types” in these statements refers to the type of the vehicle illustrated on this manual’s
cover and listed in the chart on page 7.
The number preceding each Statement of Conformity refers to the number designation for a Part or a Section of Part 571 of the
Federal Motor Vehicle Safety Standard.
The statements provided for each safety standard number are appropriate compliance representations for each Canadian safety
standard number if this incomplete vehicle, identified by the VIN on the front of the document, was manufactured by Ford Motor
Company for sale or use in Canada, except as may be noted at the conclusion of each safety standard number.
PART
565.4 The statement below is applicable to all incomplete
vehicle types except the Basic (Stripped Chassis):
This vehicle, when completed, will conform to Part 565.4,
Vehicle Identification Number, if the vehicle identification
number mounted on the top of the instrument panel is not
removed, altered, or modified and no actions are taken by
the subsequent stage manufacturer that would obstruct
the readability of the Vehicle Identification Number
mounted on the top of the instrument panel.
101 The statements below are applicable to the Chassis
Cab:
This vehicle, when completed, will conform to Standard
101, Controls and Displays if:
• The controls, displays, and their identifications supplied
by Ford Motor Company are not removed, relocated,
altered, or modified.
• The components, wiring, and power supply installed by
Ford Motor Company to illuminate any control, display,
or their identification are not removed or altered so as
to affect lighting performance.
• Components added to the vehicle do not obstruct the
driver’s ability to operate or visually locate the controls,
displays, and their identifications.
• The driver-seat is not replaced, relocated, or modified
other than for the addition of seat trim.
Any controls, displays, and illumination added to
this vehicle must conform to the requirements of this
Standard.
102 The statements below are applicable to the Chassis
Cab:
This vehicle, when completed, will conform to Standard
102, Transmission Shift Lever Sequence, Starter
Interlock, and Transmission Braking Effect, if no
alterations or adjustments are made to:
• Automatic Transmission – the transmission, shift cable,
transmission outer shift lever, shift cable bracket,
vacuum tubes, vacuum pump system, brake-shift
interlock system, the starter interlock system, and
wiring circuit from the interlock switch to the power
source.
• Manual and Automatic Transmission – the clutch-
ignition interlock system (if equipped), transmission
shift decal, knob, or transmission indicator dial
identification.
If an auxiliary transmission is added to this vehicle, it
must conform to the requirements of this Standard.
103 The statement below is applicable to the Chassis
Cab:
This vehicle, when completed, will conform to Standard
103, Windshield Defrosting and Defogging Systems, if
no alterations or adjustments are made to heater and
blower assemblies, ducting, operating controls, electrical
circuit from the blower assembly to the power source,
windshield, coolant hoses from the radiator or engine to
the heater, and if no obstructions are added that restrict
or otherwise redirect the air flow from the defroster
outlets to the windshield.
104 The statement below Is applicable to the Chassis
Cab:
This vehicle when completed, will conform to Standard
104, Windshield Wiping and Washing Systems, if no
alterations are made to the windshield, the windshield
wiping and washing system, including the electrical
circuit from the windshield wiping and washing motors to
the power source, and if no obstructions are added that
restrict or otherwise redirect fluid flow from the washer
nozzles to the windshield.