FORD SUPER DUTY F-SERIES 6C34-19A268-BA - Manual (Page 3)

1
F-SERIES
(March, 2005)
Information in this manual is furnished pursuant to United States and Canadian
safety regulations or, in some cases where the information is not required by
regulation, is furnished for the convenience of intermediate or final stage vehicle
manufacturers. Incomplete vehicles manufactured for sale or importation into
the U.S., are specially equipped for the United States. The descriptions and
statements contained in the manual relate only to motor vehicle safety standards
issued under the National Traffic and Motor Vehicle Safety Act of 1966 as
amended.
An incomplete vehicle manufactured for sale or importation into Canada is
specially equipped for Canada. This vehicle conforms to the applicable Canadian
Motor Vehicle Safety Standards (CMVSS) on the date of manufacture printed on
the cover of this manual. Requirements unique to vehicles for use in Canada are
identified in the Statements of Conformity and the “Canadian Vehicles”, page 25.
The Emission Certification Information section of this manual contains
information regarding conformity to exhaust emission regulations of the United
States, Canada, and the State of California and fuel economy regulations of the
United States.
This manual should not be relied upon with respect to compliance with any
regulation of the Federal Highway Administration or regulations issued pursuant
to the Occupational Safety and Health Act (OSHA) or any other federal,
state, or local regulations governing the performance or construction of motor
vehicles (except for those requirements shown under the heading “Unleaded
Gasoline Label,” page 26; “Warranty and Maintenance,” page 27; and “Emission
Control Information Label,” page 27). It is the responsibility of the final stage
manufacturer to determine applicability and comply with any federal, state, or
local requirements not detailed in this manual.
IMPORTANT:
UNITED STATES AND CANADIAN VEHICLES
Alterations to an incomplete vehicle by someone other than Ford Motor Company, or
damage in transit, may affect compliance statements that are furnished in this manual,
or representations that are printed on the label that may be affixed to a vehicle.
IMPORTANT:
UNITED STATES VEHICLES
Ford Motor Company has endeavored, whenever possible, to state the specific conditions
under which an incomplete vehicle may be completed to conform to each applicable
Federal Motor Vehicle Safety Standard. These specific statements are intended to aid
subsequent stage manufacturers in avoiding instances of inadvertent noncompliance
to particular standards.
Note that the final responsibility for the compliance of the completed vehicle rests with
the final stage manufacturer who is required by law to certify, as prescribed by Section
567.5 of Title 49, Code of Federal Regulations, that the completed vehicle conforms to
all applicable Federal Motor Vehicle Safety Standards and that all applicable federal,
state and California emission/noise standards are conformed with.
Ford Motor Company does not make any representation as to the appropriateness
of modifications for any particular application other than expressly stated herein.
Intermediate and final stage manufacturers must exercise proper engineering judgment
to determine if a modification is appropriate for their specific application.
INTRODUCTION
INTRODUCTION