FORD SUPER DUTY F-SERIES 6C34-19A268-BA - Manual (Page 16)

F-SERIES
(March, 2005) 14
108 The statements below are applicable to the Chassis
Cab:
This vehicle, when completed, will conform to Standard
108, Lamps, Reflective Devices, and Associated
Equipment, if all the required lighting equipment as
indicated in Table H on this page (identified by the codes
R and S) is designed and installed in accordance with
the requirements of Standard 108 and the directions
contained in this statement. Additionally, if the completed
vehicle overall length is 9.14 meters [30 feet] or more,
intermediate side marker lamps and reflex reflectors (not
supplied by Ford Motor Company) are also required for
compliance with Standard 108.
The items of equipment which are supplied by Ford Motor
Company (identified by the code S in Table H, on this
page) are designed and installed to conform to all the
requirements of Standard 108. The completed vehicle will
conform with these components if the subsequent stage
manufacturer does not remove, relocate, alter, or modify
such equipment or modify the power supply or wiring to
such equipment, and does not complete the body in such
a configuration as to impair the visibility and conformity
to the photometric requirements of the installed lamps
and reflective devices.
Specific requirements for lighting and associated
equipment are listed by incomplete vehicle type in Table
H on this page.
Lamps, reflective devices, and associated equipment
necessary to complete the vehicle from an incomplete
vehicle must conform to the equipment, locations,
special wiring, visibility, photometric, and performance
requirements of Standard 108 and to the applicable
SAE standards or recommended practices referenced
or sub-referenced in this Standard.
All electrical equipment added to the vehicle by
subsequent stage manufacturers must conform to the
wiring practices set forth in the Electrical Wiring Section
of the Ford Truck Body Builders Layout Book.
108 Canadian Requirements:
The preceding statements for Standard 108 are
appropriate compliance representations for CMVSS 108,
Lighting, and CMVSS 108.1, Headlamps, if this vehicle is
manufactured for sale or use in Canada, provided:
• No component of the Daytime Running Lamp (DRL)
system is removed, relocated, or modified.
STATEMENTS OF CONFORMITY
TABLE H
Standard 108 Lighting Equipment
Super Duty
F-Series
Completed
as Truck
or MPV
Headlamps S S
Tail Lamps S S
Stop Lamps S S
Center High Mounted
Stop Lamp (CHMSL) S N
License Plate Lamps S S
Reflex Reflectors – Side Front S S
– Side Rear R R
– Rear S S
Side Marker Lamps – Front S S
– Rear R R
Back-Up Lamps S S
Turn Signal Lamps – Front S S
– Rear S S
Turn Signal Operating Unit S S
Turn Signal Flasher (2) S S
Vehicular Hazard Warning Signal
Operating Unit
S S
Vehicular Hazard Warning Signal
Flasher
S S
Identification Lamps – Front N(1) S(1)
– Rear N R
Clearance Lamps – Front N(1) S(3)
– Rear N R
Parking Lamps S N
S Required on completed vehicle and supplied with the
incomplete vehicle.
R Required on completed vehicle and not supplied with the
incomplete vehicle.
N Not required for completed vehicle.
(1) Supplied on DRW Super Duty F-Series Chassis Cab.
Optional on SRW Super Duty F-Series Chassis Cab.
(2) Designed for two turn signal lamps per vehicle side (one front
and rear). If additional lamps are required, replace the turn
signal flasher with one having the correct lamp load rating.
(3) If a second unit body width is greater than 2032 mm [80 in] or
higher than the chassis cab body, additional clearance lamps
may be required that comply with this standard.
Width less than 2032 mm [80 in] Width 2032 mm [80 in] or more Item