Fluke 9107 - Manual (Page 19)

5 Quick Start
5.1 Unpacking
Unpack the dry-well carefully and inspect it for any damage that may have oc-
curred during shipment. If there is shipping damage, notify the carrier
immediately.
Verify that the following components are present:
• 9105 or 9107 Dry-well
• 2173 Insert, 1/4” Aluminum
• Power Cord
• Manual
• Two Well Insulators (9107 only)
• Tongs (insert removal tool)
5.2 Set-up
Place the calibrator on a flat surface with at least 6 inches of free space around
the instrument. Overhead clearance is required. DO NOT place under a cabinet
or structure. Plug the power cord into a grounded mains outlet. Observe that the
nominal voltage corresponds to that indicated on the back of the calibrator.
Carefully insert the probe sleeve into the well. Probe sleeves should be of the
smallest hole diameter possible still allowing the probe to slide in and out eas-
ily. Sleeves of various sizes are available for Hart Scientific. The well must be
clear of any foreign objects, dirt and grit before the sleeve is inserted. The
sleeve is inserted with the two small tong holes positioned upward.
Turn on the power to the calibrator by toggling the switch on the power entry
module. The fan should begin quietly blowing air through the instrument and
the controller display should illuminate after 3 seconds. After a brief self-test
the controller should begin normal operation. If the unit fails to operate please
check the power connection.
The display will begin to show the well temperature and the well heater will
start operating to bring the temperature of the well to the set-point temperature.
5.3 Power
Plug the dry-well power cord into a mains outlet of the proper voltage, fre-
quency, and current capability. Typically this will be 115 VAC (±10%), 50/60
Hz (230 VAC ±10%, 50/60 Hz). Turn the dry-well on using the rear panel
9105/9107 13
5 Quick Start